Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateCraftsman Weather Seal Replacement: The Sunrise Manor Owner’s Guide
We replace Craftsman-compatible weather seals in Sunrise Manor with same-day service, and most jobs land between $150 and $300 installed depending on seal type, door width, and whether the bottom retainer needs replacing. Craftsman uses a handful of different seal profiles across its model years, so the price swings on which one your door actually takes. You usually find out the seal is done the same way everyone else does: a dust line across the garage floor after a wind event, or a hot August afternoon when the gap under the door lets in enough desert silt to coat everything you own.
Which Craftsman Models This Applies To
Craftsman garage doors were sold through Sears under a wide range of model numbers, and the same weather seal doesn’t fit all of them. The most common residential lines use a 1-3/4-inch or 2-inch aluminum or vinyl bottom retainer with a slide-in bulb or U-shaped seal. Older Craftsman doors (roughly pre-2005) often have a narrower retainer that takes a different profile than the newer ones. The number on the door’s model sticker inside the jamb or on the end stile is what we need to match the right part.
The other compatibility gotcha: Craftsman rebadged doors from more than one manufacturer over the years, so a model number that looks like one series may actually be built on a different bottom section entirely. Measure the retainer width at both ends and the inside channel depth before ordering anything. On the OEM-versus-aftermarket question, we’ll tell you straight: the genuine Craftsman seal is fine when you can find it, but for most Sunrise Manor doors a quality aftermarket bulb seal in the same profile holds up better in our heat and costs less. Sun and 100-degree summers are harder on vinyl than the factory tested for.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Craftsman Weather Seal Replacement Is Failing
The seal is one of the cheapest parts on the door and one of the first to go in Southern Nevada. Here’s what usually tips people off:
- A visible gap under the door in daylight. The seal has compressed flat or torn away from the retainer, and the door no longer touches the floor evenly.
- Dust and sand inside the garage after a wind. Sunrise Manor sits in a windy corridor, and a failing seal funnels fine desert grit straight into the garage.
- Water pooling at the threshold during monsoon rain. The bottom seal is supposed to shed water; when it’s cracked or brittle, water wicks under it and pools at the door line.
- A hard, cracked, or crumbling seal. UV exposure cooks vinyl faster here than almost anywhere in the country, and a seal that should last several years can get chalky and brittle in a couple of seasons.
- Cold or hot air rushing in around the bottom. A draft at the floor means the seal has lost its bulb shape and no longer makes contact with the slab.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the price picture for Craftsman weather seal replacement in Sunrise Manor. These are installed prices, parts and labor together, quoted before we start and held at that number:
| Job | Installed Price |
|---|---|
| Bottom weather seal only (standard width) | $150 – $250 |
| Bottom seal plus retainer replacement | $200 – $300 |
| Bottom seal plus side and top seals (full perimeter) | $250 – $350 |
What drives the range: door width (single versus double), whether the existing retainer is reusable, seal profile (standard bulb versus heavy-duty/commercial grade), and whether we’re also replacing the side and top seals while we’re there. Parts-plus-labor is bundled so you see the real number, not a lowball parts price with labor tacked on later. Every seal job carries our 90-Day Done Right Promise in writing, and if a seal we installed fails inside that window, one call brings us back.
DIY or Call Us?
Weather seal on the bottom of the door is the one garage door part most homeowners can safely tackle, and we won’t pretend otherwise. A bottom seal swap doesn’t involve springs or cables under tension, so the danger is low. What goes wrong is the match: people order the wrong profile, force a seal into a retainer it doesn’t belong in, or discover mid-job that the retainer itself is bent or rusted and needs replacing too. That’s usually when we get the call, halfway through, with the door stuck open in the driveway.
If you want to check your own seal first, run your hand along the bottom edge while the door is closed and look for light, gaps, or a seal that’s rock-hard. If the retainer is straight and the profile is standard, it’s a reasonable project. If anything looks off or you’d rather not spend an afternoon on it, call us at (888) 274-8795. We’ll quote it on the spot and get it done the same day in most cases.
FAQs
How long does a weather seal last in Sunrise Manor?
Three to five years for a standard vinyl seal, shorter on doors that face full afternoon sun. Our UV and heat cycle vinyl much faster than cooler climates, so expect the low end of that range on a west-facing door.
Can my weather seal be repaired instead of replaced?
Rarely. A seal that’s compressed, cracked, or torn can’t be glued or patched back into working shape, and a seal with a gap is no seal at all. Replacement is the fix, and it’s inexpensive enough that repair rarely makes sense.
How long does the swap take?
Usually an hour or less for a bottom seal, and about 90 minutes if we’re doing side and top seals too. Same-day service is available on most seal jobs.
How do you source the right Craftsman seal for my door?
We match on the model number and retainer measurement, not just the brand name, so the profile and width actually fit. We source quality aftermarket seals in the correct profile since they hold up better in our climate than the original vinyl. Note we’re an independent service provider and not affiliated with Craftsman, though we work on Craftsman doors and LiftMaster, Chamberlain, and Genie equipment regularly.
If your Craftsman door is letting in dust, water, or hot air, don’t wait for the floor to get worse. Call (888) 274-8795 for a free estimate. We’ll quote the seal, tell you if the retainer needs replacing too, and hold that price when we show up.
Written by the team at Otto’s Garage Door Sunrise Manor, serving Sunrise Manor and nearby areas.